Installation of a Trailer Brake Controller on a 2008 Ford F-150 - etrailer.com, http://www.etrailer.com/bc-2008_Ford_F-150.htm
Today, on our 2008 Ford F-150, well be installing the Tekonsha Prodigy P2 Brake Controller. In conjunction with the Tekonsha plug-in wiring adapter for electric brake controllers for Ford, Lincoln and Mercury, Part Number 90885-3035P.To begin with, we will need to locate a suitable location where well mount our brake controller. On this particular vehicle, the customer has asked that we put the brake controller in the center pocket just above the manual shifter for the two and four-wheel drive selector.To begin with, well need to remove the lower fascia that goes around the interior dash. Youll need to remove the two push pins, one on each side to remove this. Now that we have this side out of the way, well go ahead and check up behind where we want to mount our brake controller and make sure that there are no wires or anything else that we can potentially damage when we mount our brackets.Now that weve checked this out and make sure that everything is clear behind it, well go ahead and take a suitable location in the pocket. As you will see in this particular vehicle, theres already a little switch just to the left of where we need to mount the brake controller.We need to make sure that we leave plenty of room to still reach that switch.
Note: Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information..
 |
| Installation of a Trailer Brake Controller on a 2008 Ford F-150 - etrailer.com |
Download Video
Installation of a Trailer Brake Controller on a 2008 Ford F-150 - etrailer.com, Autos, how to use ford f150 trailer brake controller,
0 Response to "Installation of a Trailer Brake Controller on a 2008 Ford F-150 - etrailer.com"
Post a Comment