Installation of a Trailer Brake Controller on a 2008 Ford Ranger - etrailer.com, http://www.etrailer.com/bc-2008_Ford_Ranger.htm
Today on our 2008 Ford Ranger we're going to be installing the Tekonsha Prodigy P3 Brake Controller part number 90195 along with the etrailer brake controller install kit part number ETBC7. To start we'll first go ahead and assemble the 7-pole adapter bracket. With the hardware provided we'll use it to attach the bracket to the 7-pole adapter. We'll go ahead and take the bracket and feed it over the wires and up to the back of the mounting surface for the 7-pole adapter. Then we'll take the screws, feed them through the front side of the 7-pole and secure it with the nuts on the backside. Once we have all four in place we'll go ahead and tighten them down. Now once we have the bracket mounted to help secure our wires and clean up our install look we're going to go ahead and tape it up here until we get to the 4-pole connector. Using some black electrical tape, it'll help bundle it up and protect our wires.
Note: Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information..
 |
| Installation of a Trailer Brake Controller on a 2008 Ford Ranger - etrailer.com |
Download Video
Installation of a Trailer Brake Controller on a 2008 Ford Ranger - etrailer.com, Autos, how to use ford f150 trailer brake controller,
0 Response to "Installation of a Trailer Brake Controller on a 2008 Ford Ranger - etrailer.com"
Post a Comment